- 1). Position a jack under the transmission of your Jeep to support the transmission and transfer case. Locate the four studs in the center of the transfer case skid plate that retain the bottom of the transmission/transfer case mount. Remove the nuts and washers from the studs with a ratchet or socket.
- 2). Locate the skid plate mounting bolts that run down the frame rails. There are six bolts total, three along each side. Loosen the nuts on all six bolts with a socket and ratchet, then remove the nuts by hand while supporting the skid plate. Lower the plate to the ground and set it out of the way.
- 3). Locate the four mounting bolts on the transmission/transfer case mount that attaches it to the transmission. Remove the four bolts with a socket and ratchet. Remove the mount and discard it.
- 4). Install the new transmission/transfer case mount on the transmission and install the four mounting bolts. Tighten them with a socket and ratchet. Position the transfer case skid plate under the Jeep and align the bolt holes. Install the six bolts that support the skid plate on the frame of the Jeep.
- 5). Tighten the skid plate mounting bolts with a socket and ratchet. Install the nuts on the four mounting studs from the transmission/transfer case mount. Tighten with a socket and ratchet.
- 6). Remove the jack from under the transmission and test drive the Jeep. The new mount will eliminate any movement that was in the drive train if it is installed correctly.
previous post