- 1). Press in the indent on the side of the hand wheel disk. This stops the needle from going up and down while you fill the bobbin.
- 2). Put the thread onto the spool pin on the top of the machine.
- 3). Grip the spool cap and slide it over the the edge of the spool of thread to prevent the thread from tangling.
- 4). Gently pull the thread, and push through the spool guide post.
- 5). Take the thread and lead it clockwise around the front of the tension disk.
- 6). Push the thread through the small hole of the bobbin from the inside.
- 7). Put the bobbin on the spindle and click it to the right.
- 8). Press on the speed control of the sewing machine until the bobbin is full or you have reached the desired quantity of thread.
- 9). Cut the thread, push the bobbin to the left and remove it from the spindle.
- 10
Press on the indent button to re-enable the sewing mode on your machine.
previous post