- 1). Cut nine pieces of memory wire. Cut the memory wire about an inch longer than the size you need.
- 2). Take your pliers and make a loop at one end of each piece of memory wire. The loop should be turned toward the outside of the wire. Try to close the loop as tight as possible so your beads won’t fall off of it.
- 3). Start stringing the seed beads onto the memory wire. There should be the same amount of beads on each piece of wire. As you finish putting the beads on each piece, form a loop at the end the same way you did the first ones.
- 4). Cut two 2-inch pieces of beading wire and make a loop at one end of each piece. The loops need to be big enough that they will not slide through the loops on the memory wire.
- 5). Slide one piece of beading wire through the memory wire loops and make another loop at the end of the beading wire. All nine pieces of memory wire should be secured at one end to the beading wire.
- 6). Separate the beaded memory wire into three sections of three. Start at the secured end of the bracelet and braid the three sections together.
- 7). Slide the other piece of beading wire into the unsecured end of the bracelet and make a loop at the end of the beading wire.
previous post