- 1). Press in on the release tabs that are located on the side of the trimmer head at the end of the shaft; these tabs hold the spool in place.
- 2). Pull the spool off the trimmer head and remove any leftover string from the spool.
- 3). Cut two pieces of double-helix WORX string to lengths of 25 feet with a pair of scissors.
- 4). Feed the tip of one string into the hole that is located on the inside edge of the spool and then feed the string around the spool in the direction indicated by the arrow at the top of the spool; stop when you have 6 inches left unwound. Press the remaining string into the tab on the spool’s edge.
- 5). Place the second string into the second hole and then wind it as you did the first string.
- 6). Slide the spool back onto the trimmer shaft. Place the cover over the spool and then feed the strings through the holes on the sides of the cover. Snap the cover in place and then pull hard on the strings to release them from the side of the spool.
previous post
next post