- 1
Determine the battery ground.Ablestock.com/AbleStock.com/Getty Images
Open the tractor hood and determine how the electrical circuit is grounded. The 8N originally came with a positive ground from the factory. Previous owners may have upgraded the electrical system to a negative ground. Locate the battery and determine which battery cable extends directly to the frame of the tractor. Disconnect that grounded cable from the battery terminal with the correct wrench and lay aside. - 2
Farming in a simpler time.Miguel Villagran/Getty Images News/Getty Images
Locate the starter on the engine block. It is located near the rear of the motor where it is bolted to the bell housing. Determine if the starter is actuated by a hand lever located under the lower right side of the dash cowl or via an electrical solenoid usually found on top of the starter. If lever-actuated, disconnect the articulated linkage located above the starter housing by removing the cotter key and retaining pin with a punch. If there is an electrical solenoid, disconnect the main power cable from the solenoid to the starter with a wrench, unscrew the solenoid mounting screws holding it to the starter casing and lay it aside. - 3). Remove the two bolts holding the starter to the engine block using the correct socket and extension. Pull back on the starter, and lift it out the rest of the way. Once removed, put a matching nut onto the two bolts and snug them down. These bolts also hold the starter assembly itself together. By securing the bolts, it will prevent the armature from falling out or separating from the starter housing.
previous post