- 1). Open the hood and mount the LiteGlow control box in a spot near the vehicle's battery with mounting fasteners included in the kit. The control box must be mounted in a spot that stays cool and dry.
- 2). Raise the vehicle using a floor jack and support it with jack stands placed under the vehicle's frame rails if their will not have be enough clearance for you to move underneath. Do not go under the vehicle unless you are sure it is secure jacked.
- 3). Place one LED light against the chassis, then make sure the LED's cord can extend to the control box. This might require the assistance of a second person. Adjust the position of the light or control box as needed.
- 4). Tie the LED strip of the kit to the chassis using its zip-tie cords. Make sure the strip is straight and extended as tight as possible. Repeat for all remaining strips.
- 5). Plug the cords of each LED strip into the control module's ports.
- 6). Disconnect the negative (black) cable on the battery using a wrench on the cable clamp nut. Disconnect the positive (red) battery cable second.
- 7). Connect the control module's positive wire to the positive battery terminal, slipping its lead within the cable clamp, and then tightening the clamp. Then connect the positive wire and return the battery cables into position.
previous post
next post