- 1). Unscrew the electrical access panel from the rear of the dryer. Look for the terminal block that has three terminals on it.
- 2). Loosen the nuts on the terminal block. Slide the black and red wires from the dryer cord into place on the outer terminals. The order of these does not matter. Connect black or red to either side. Tighten the nuts for these terminals.
- 3). Slide the white wire into position on the center terminal. Tighten this nut. Slide the green (ground) wire into place under the green screw on the dryer housing. Tighten this screw down.
- 4). Replace the dryer electrical access panel. Plug the dryer into the wall outlet and turn it on to test it.
previous post