- 1). Unplug the vacuum cleaner to prevent accidental operation, and pull the hose out of the cleaner.
- 2). Release the handle, and lay it on the floor to make changing the belt easier.
- 3). Grip the nozzle control knob, and pull it off the machine.
- 4). Flip the machine over so the bottom of the nozzle faces up.
- 5). Remove the bottom plate attached to the nozzle by inserting the screwdriver into the wide slot on the right of the nozzle and pushing the screwdriver handle forward. This will release one of the bottom plate latches. Repeat with the slot on the left of the nozzle.
- 6). Turn the bottom plate, and lift it off the nozzle.
- 7). Slide the screwdriver into the slot near the left wheel, and lift the handle up to release the latch. Repeat the process on the slot next to the right wheel and the slots on the right and left side of the nozzle near the agitator brush.
- 8). Pull the agitator brush out of the nozzle, and remove the old belt.
- 9). Wrap the new belt around the agitator brush pulley, and place it back in the nozzle.
- 10
Line the tabs of the bottom plate with the slots on the nozzle, and press down until it snaps in place. - 11
Flip the machine over so the top of the nozzle is facing up, and lift off the nozzle cover. - 12
Grap the replacement belt, and stretch it over the motor pulley. - 13
Turn the agitator by hand to ensure it's not obstructed. Move the belt to the middle of the pulley if needed. - 14
Line up the nozzle cover over the nozzle, and press down until it clicks in place. - 15
Replace the control knob by pressing it onto the vacuum until it snaps in place.
previous post