- 1). Sweep the floor where you plan to install the press. Check with a level to ensure the floor does not slope.
- 2). Move the press into place. Set it out from the wall to provide enough space for work pieces. Check the uprights with the level and make sure the press does not lean.
- 3). Use the hammer and punch to mark the floor in the location of the mounting holes. Move the press out of the way.
- 4). Drill a half-inch hole three inches deep at the marked locations. Sweep away the debris left by drilling.
- 5). Re-position the press over the holes. Drop a concrete anchor into each hole. Use the wrench to tighten the nut on each anchor.
- 6). Bleed the jack on the press according to the instructions in the owner's manual.
previous post
next post