- 1). Turn the Doberman security water detector alarm over and remove the battery compartment lid. Insert two fresh AAA batteries into the battery compartment and close the lid.
- 2). Remove the paper backing from the back of the Doberman. Place the Doberman against a wall, if monitoring against leaks in a basement, or against a washing machine, if monitoring against leaks of the fittings providing water to the machine. Press the Doberman against the wall or object to adhere it to the surface.
- 3). Pull the probe to extend its wiring attached to the Doberman. Place the tip of the probe against the floor so that any water leakage that occurs will touch the tip. If necessary, tape the probe to the floor with masking tape.
- 4). Check that the LED on the Doberman is glowing a solid green before proceeding. If not, check the placement of the batteries in the battery compartment.
- 5). Press the red "Test/Reset" button once to test the Doberman security water detector alarm. Press the button and hold it in once the alarm sounds to reset the detector.