- 1). Select a table with sturdy legs. The built-up epoxy resin will be heavy and requires substantial support. Clean the table of any dirt, dust or stains.
- 2). Apply masking tape on the underside of the table, along the edge, to protect the bottom of the table from drips. Place newspapers under the table to catch drips.
- 3). Use a hot glue gun to secure your decorative items to the tabletop.
- 4). Seal the table and decorative items with a mixture of four parts white glue to one part water. Paint the mixture onto the tabletop and allow at least four hours drying time. The sealant coat must be completely dry, with no wet spots, before proceeding to the epoxy resin coat.
- 5). Open the windows to provide ventilation. Put on protective gloves before working with the epoxy resin.
- 6). Mix the epoxy resin according to the manufacturer's directions. The amount will vary, depending on the size of the tabletop and the amount and type of objects you are embedding in the resin. Use the coverage guidelines provided by the epoxy resin product to determine the quantity to mix.
- 7). Pour the mixed epoxy resin evenly over the tabletop. Most epoxy resins will pour to a thickness of 1/16 inch to 1/8 inch. Use the mixing stick to move the epoxy resin over the surface of the table until the tabletop has an even coat. Smooth the epoxy resin along the edges of the table with the mixing stick.
- 8). Watch for any air bubbles that may develop in the next 30 minutes. Remove the air bubbles by gently blowing on them through a straw or holding a propane torch at least 6 inches from the surface and moving it quickly over the surface. Use a toothpick to pop any bubbles that remain.
- 9). Use tongue depressors to scrape off excess epoxy resin from the bottom edge of the table. Wait until the epoxy resin begins to thicken before scraping away the excess.
- 10
Protect the tabletop from settling dust. Suspend a tarp over the tabletop using tall chairs positioned around the table to anchor the tarp and hold it off the surface of the table. - 11
Allow the epoxy resin to cure for the time recommended by the product. Apply additional coats of epoxy resin, following the application process, until you achieve the desired thickness. - 12
Remove the masking tape from the underside of the table after the final coat of epoxy resin has cured. Remove any remaining drips with 200-grit sandpaper.
previous post