The need of home security system is increasing along with the increasing number of crime. One of the most popular security systems which is available for you today is security lighting. It has motion detector which can be easily installed to an existing light fixtures. The following are some step of installing security lighting onto the existing electrical source.

The first thing to do is to look for correct fuse or breaker to an exterior light you are going to use with electrical project. Turn off the fuse or breaker and then use voltage tester to make sure that the power is off. Take your new fixtures and look at the instruction to see how to install the fixtures. Prepare the fixtures to make sure that it is ready to use.

The next thing you have to do is to remove the existing fixtures to replace it with the new sensor light. You can start it by unscrewing the fixtures using screwdriver. After you have already removed the old fixtures, you can get the base of your new motion light. Give a sign to which your screws will go. If you find that the holes don't perfectly match up, you can put wood, masonry, or metal bit and drill where you have marked. Before you fasten the light, you should see the source wires through the middle base.

If you are sure that the base is ready, you can match up the source wire toy our new fixtures wires. Uneven and too long existing wires can be solved by using wire cutters and stripping the plastic off aroundinch. Then, screw in the wire caps.

After you make sure that you have everything done nicely and tightly, you can put the light fixtures to the base to make sure that the rubber seal has been kept evenly prior to screwing on the fixtures. Then, turn on the power to see whether the light can turn on when you move across the sensor.