- 1). Turn on the printer and open its top cover.
- 2). Push the imaging drum up and away from you until it is completely out of the printer.
- 3). Wipe off any accumulated dust from the clear plastic in the bottom of the opening with a soft, dry cloth.
- 4). Cut open the plastic bag that contains the new imaging drum with a pair of scissors. Lay the imaging drum on a solid, stable surface, such as a table.
- 5). Pull the orange rings so that you release the shipping pins on each end of the imaging drum and remove the two orange shipping locks.
- 6). Remove the two orange shipping spacers and remove the orange cover from the imaging drum.
- 7). Match up the arrows in the printer so they are even with the white roller part of the imaging drum, and press it in place.
- 8). Close the cover and press the "Go" button on the printer's control panel. The ready light will turn on in a few seconds.
previous post
next post