The springs located on the will eventually break down and lose some of their tension after a certain period of time. Replacing these high tensioned springs may prove challenging and dangerous. Thus, these are highly suitable for those who have a lot of experience in this craft. There are numerous types of doors. This implies that there are also numerous types of springs, as well as their individual garage door repair techniques. For instance, you may have to use extension springs so your garage door will properly operate. If that does not work, tension springs may do the trick.

Power Disconnection
In replacing springs for repair, you need to remember to close the garage door before anything else. You should unplug the power cord that directly connects to the opener of the. If your opener is permanently hardwired to the electrical system of your building, you should disconnect your circuit breaker intended for your garage area. Another option would be to remove the fuse of the garage door opener. New door models typically have neutral positions that you may utilize so you can properly position your opener. You may use this to your advantage while you replace your springs. On the other hand, you may have to disconnect the entire opener from the main system for older door models.

Comparison
You should also make sure that the old springs and the replacement springs are of the same size before you perform garage door repair. You need to measure the diameter and the length of your old garage door springs while they are set in place. Also, you need to compare these springs with the new ones. You should also make sure that you will mark the exact position of the spring cone. A chalk or a marker will do just fine.

Tension Elimination
To help release the overall tension on the bar of the, you need to unwind old springs. You should insert the winding bar in one of the cone holes for winding. In this light, you should make sure that this bar is around 18 inches. The diameter should just be right for the winding cone. Using a wrench, you need to unscrew the setscrew portion of the spring. Then, you should pull down the winding bar. While you are holding one of the bars into place during garage door repair, you need to insert another winding bar in another hole. Finally, you have to let go of the first bar while you are pulling down using the second bar. You should repeat this entire process until such time that the garage door spring is unwound. Also, you have to perform these things until you find that there is no more tension on the bars. After these, you are ready to slide in the new spring.

While performing these repair maneuvers, you should not touch the winding cones. You are also highly discouraged to grasp the old garage door springs while these are set into place.