Fishing is easy no doubts to an avid angler, but the fishing knots are a little complicated to deal with in the beginning - even the expert fishermen would agree.
There are so many such knots in fishing; it only further makes it more confusing and intimidating to a beginner.
What kind of a knot should ideally be used in fact depends on the type of fish one is actually looking to catch.
Fishing requires a lot of stuff; of these the fishing lines are quite important.
Lines are supposed to be used according to the fish size and the water type.
Saltwater fish need different types of fishing tackle than freshwater fish.
Since the tackles vary, the knots also vary.
Knots needs to be nothing less than prefect but all types of knots cannot be tied on a single type of line.
There are two reasons for it.
Firstly, the knots will not hold on a wrong line and second, if the knots are not tied properly, it will not serve the purpose and the fishermen will lose the fish even when it is almost hooked.
Many novice anglers do can't seem to ascertain the cause behind losing fish.
They assume it is the hook, the line, or other terminal tackles - it is the knot.
It is the knot strength that is the lone explanation behind anglers losing fish.
When you are out there fishing, keep in mind what kind of a fish are you targeting and then you can complement it with the appropriate fishing tackle.
For example if you are going bass fishing, there are some specific knots that work best.
A trilene knot is the best knot for beginners.
It is simple and dependable at the same time.
This knot is used in joining hooks, artificial lures, snaps, and joining lines to swivels.
The unique double warp design of the knot gives it a strong and reliable connection.
Firstly, you have to run end of line through lure or the eye of the hook, and then double back through the eye a second time.
Now you have to loop for 5 to 6 times around the standing part.
Thread tag end of the line back between the eye and the coil.
Without hesitating, tighten the knot with a steady even motion.
Leave about 1/4" and trim the tag.
The palomer knot is also quite a favorite of bass fishermen.
Here is how to get it right this knot provides a protective cushion for added strength knot.
Double the line to make a loop of about three or four inches long.
Now you need to pass the end of the loop through hook's eye.
Now hold the standing line between the thumb and the finger, while with your free hand grasp the loop and form a simple overhand knot.
Take your hook and then pass it through the loop and draw line while you guide it over the top of the eyelet.
Tighten the knot snugly by pulling the tag end and trim it to about 1/4th".
These two knots are the favorites of bass fishermen and also the most affective.
So what are you waiting for? Practice and practice till you get it right and when you are a pro at it, go catch some bass.
Happy Fishing and Tight Lines!