- 1). Move the ignition switch on the Craftsman into the "Off" position. Unscrew the starter assembly cover and remove it from the trimmer using the screwdriver. Flip the starter cover over to replace the pull cord.
- 2). Cut the old cord off the pulley and the starter handle. Throw the old cord away. Push the new cord through the middle of the pulley, the hole in the starter cover and the center of the starter handle.
- 3). Tie a knot above the starter handle and at the base of the pulley. Wind the cord around the pulley until 10 inches remain unwound. Form a loop into the unwound portion.
- 4). Pinch the loop at the bottom and wiggle it back and forth until the recoil spring hooks onto the pulley. Hold the starter cover and wind the loop and pulley four to six revolutions to tension the recoil spring. Press and hold the pulley with your thumb.
- 5). Let go of the loop and unwind the cord. Lift your thumb off the pulley slowly to let the cord rewind onto the pulley. Add additional revolutions if the handle isn't tight against the starter cover. Fit the starter cover back onto the engine and tighten it into place.
previous post